AXIOMTEK MANO861 Bedienungsanleitung PDF herunterladen (Seite 23)

MANO861 Mini ITX Board

Hardware Installation 17

Chapter 3

Hardware Installation

Take note of the following precautions before you install motherboard components or change

any motherboard settings.

Caution

 Unplug the power cord from the wall socket before touching any component.

 Use a grounded wrist strap or touch a safely grounded object or a metal

object, such as the power supply case, before handling components to avoid

damaging them due to static electricity.

 Hold components by the edges to avoid touching the ICs on them.

 Whenever you uninstall any component, place it on a grounded anti-static pad

or in the bag that came with the component.

 Before you install or remove any component, ensure that the ATX power

supply is switched off or the power cord is detached from the power supply.

Failure to do so may cause severe damage to the motherboard, peripherals,

and/or components.

3.1 Motherboard Overview

Before you install the motherboard, study the configuration of your chassis to ensure that the

motherboard fits into it. Refer to the chassis documentation before installing the motherboard.

Warning

Make sure to unplug the power cord before installing or removing the

motherboard. Failure to do so can cause you physical injury and damage

motherboard components.

3.1.1 Placement Direction

When installing the motherboard, make sure that you place it into the chassis in the

correct orientation. The edge with external ports goes to the rear part of the chassis as

indicated in the image below.

3.1.2 Screw Holes

Place four (4) screws into the holes indicated by circles to secure the motherboard to the

chassis.

Caution

Do not over-tighten the screws! Doing so can damage the motherboard.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

Keine Kommentare

AXIOMTEK MANO861 Bedienungsanleitung Seite 23